Step 1 Launch DiskPart in the command prompt by typing diskpart. When get to the drive partition, you can create disk partition with MBR partition style. DISKPART> convert gpt The disk you specified is not MBR formatted. After this, you will be able to create a primary partition and mark it as active. Change partition ID; after step 3.5, run cmd as administrators. Create a partition. However, you can only make 4 disk partitions with MBR style. In DiskPart I did: DISKPART> select disk 1 Disk 1 is now the selected disk. These exceptions include using the gdisk (you can also use parted, but if you are familiar with fdisk it makes sense to just use gdisk) instead of the fdisk command. However, make sure you back up the data from the disk as it will be deleted. At the DISKPART prompt, type: CREATE PARTITION PRIMARY SIZE=10000 (Change the word PRIMARY to EXTENDED to create an extended partition. Here I’m creating a primary partition at the beginning of the free space and spans entire disk. For instance, if your extracted install.wim file is around 10GB, create a new partition that is around 12GB. Migrate OS from MBR to MBR disk and ensure you … Clone Partition: copy partition to another hard drive 4. I haven't tried DISKPART CLEAN because I don't want to lose my data (on the ext4 system partition). 10. select disk 1 list partition. Create a new partition on either unallocated space or an existing partition. The size of the gpt disk must be at least 32 MB to create a Microsoft Reserved partition. 5. open disk part; 1 - DISKPART> select disk 0 2 - DISKPART> list partition 3 - DISKPART> select partition 1 (Now, select the recovery partition) [4 is Optional for don't remember recovery part] Creates a Microsoft Reserved (MSR) partition on a GUID partition table (gpt) disk. How to create an MBR Partition Preamble: For all extensive purposes follow the same instructions for a GPT partition, keep in mind there are a few exceptions. Hi, everybody, if you want to hide recovery partition ? What makes you think that the disk is MBR? DISKPART> clean DISKPART> convert mbr (or gpt) DISKPART> create partition primary DISKPART> select part 1 DISKPART> active (if this is the boot partition) DISKPART> format fs=ntfs label=(name) quick DISKPART> assign letter (letter) DISKPART> list volume: Use Diskpart command to Create and Format Partitions. DISKPART> clean DISKPART> convert mbr (or gpt) DISKPART> create partition primary DISKPART> select part 1 DISKPART> active (if this is the boot partition) DISKPART> format fs=ntfs label=(name) quick DISKPART> assign letter (letter) DISKPART> list volume. Follow the listed steps to delete the partition with DiskPart. A Microsoft Reserved partition is required on every gpt disk. 3. To create a logical partition for example: Now, create a new partition that is a couple of gigabytes bigger than the size of the install.wim file. 5. create partition primary. Step 2 Type list disk and then press 'Enter' to list down all the available partitions. The size of this partition depends on the total size of the gpt disk. Thanks for your replies. Press 'Enter.' This can be primary or logical depending on your setup. You will see the prompt "Diskpart successfully converted the selected disk to GPT format." Step 7 Create a new partition by typing create partition primary and press ''Enter'.' This means you have set your PC to GPT partition style. Move Partition: change the location of a partition. If you do not set a size -- in megabytes -- such as the above example for 10 GB, then all available space on the disk will be used for the partition. 1.2 Copy Windows 10 Installation Files to Recovery Partition. The following are common errors displayed if you miss a step: DISKPART> clean To specify size, e.g 1 GB, use create partition primary size=1024. You can use Command Prompt and DISKPART to clean the drive entirely and convert it to MBR easily.